Gate WarFET Mosfet

Product description

Very high quality mosfet circuit. The Mosfet circuit reduces the wear on contact surfaces, lowers the reaction time when firing and increases the rate of fire. Third generation mosfet.
The circuit itself measures 56x20x9mm.

This mosfet is very advanced (technically, not installation wise) and is programmable via the small controller that comes with a variety of functions;
1 . 1-5 round burst capability.
2. Switch fire-selector between semi-burst-auto. You can only have two active at the same time.
3. Pre-cocking that tightens the springn for faster response on semi.
4. "Smart Trigger".
5. ROF control. 6. Active Brake and the possibility of on/off on this.
7. "Dark Mode", turns off all LEDs on the circuit.

Note that the programming board is only intended for WarFET and cannot be used to program for example Merf 3.2 or NanoHARD.

Other than this does the mosfet have a lot of good qualities;
1. Protection for Li-Poly/Li-Ion/LiFePo4/Ni-CD batteries.
2. Electronic safety as protection against short circuits and the like.
3. Mosfet with all its advantages such as increased fire response etc.
4. Debouncing.
5. Built in "Self-Test", if your AEG is malfunctioning this can show if the fault is in the circuit.

Made to handle up to 14.8V but we strongly recommend not going above 11.1V.

There are two different possibilities for connection:
- Plug'n'play: You don't need to solder signal cables but connect as usual, however with the mosfet between battery and socket. Note that not all functions work via this connection.
- Soldering of the SA: You solder one or two signal cables into your box, this results in faster response and you get access to all functions.
New with this mosfet is that it also comes with an adapter for tamiya connectors, which are usually standard in AEG.

In addition to the circuit, it also includes:
- Control for programming.
- Single signal trigger wire.
- Dual signal trigger wire.
- Tamiya adapters for battery and motor.
- A pair of Deans connectors
- Quick start guide.

To ensure the function of your circuit, we recommend 11.1V LiPO for all applications with M120-spring or stronger. However, consider the strain this trim places on other components such as gears and pistons. It is especially important that your gearbox is shimmed correctly when using a circuit.

Give feedback on this product description